Instantly download NSE7_FSN_AR-7.6 updated real questions

Fortinet NSE7_FSN_AR-7.6 Exam Overview:

Fortinet NSE7_FSN_AR-7.6 Exam Syllabus Topics:

Fortinet NSE 7 - Secure Networking 7.6 Architect Sample Questions:

1. Refer to the exhibit, which shows the output of diagnose sys session list.

If the HA ID for the primary device is 0, what happens if the primary fails and the secondary becomes the primary?

A) The session state is preserved but the kernel will need to re-evaluate the session because NAT was applied.
B) The secondary device has this session synchronized; however, because application control is applied, the session is marked dirty and has to be re-evaluated after failover.
C) Traffic for this session continues to be permitted on the new primary device after failover, without requiring the client to restart the session with the server.
D) The session will be removed from the session table of the secondary device because of the presence of allowed error packets, which will force the client to restart the session with the server.

2. Exhibit.

Refer to the exhibit, which shows two entries that were generated in the FSSO collector agent logs.
eeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeeee What three conclusions can you draw from these log entries? {Choose three.)

A) A firewall is blocking traffic to port 139 and 445.
B) DNS resolution is unable to resolve the workstation name.
C) The user ' s status shows as " not verified " in the collector agent.
D) Remote registry is not running on the workstation.
E) The FortiGate firmware version is not compatible with that of the collector agent.

3. Refer to the exhibit.

Assuming a default configuration, which three statements are true? (Choose three.)

A) Strict RPF is enabled by default.
B) User B: Fail. There is no route to 95.56.234.24 .
C) User C: Fail. There is no route to 10.0.4.63 using port1 in the touting table.
D) User A: Pass. The default static route through wan1 passes the RPF check regardless of the source IP address.
E) User B: Pass. FortiGate will use asymmetric routing using wan1 to reply to traffic for 95.56.234.24.

4. A VPN tunnel is up. To monitor traffic flow, the administrator enters the following CLI commands on an SSH session on FortiGate:
# diagnose debug enable
# diagnose sniffer packet any ' udp and port 500 ' 4
However, the sniffer does not show any output. Assuming default configuration values, what are two possible reasons there is no output? (Choose two answers)

A) The sniffer must be restricted to the remote peer IP address.
B) The sniffer output will be ignored because running diagnose debug enable shows only application real- time debugs.
C) NAT Traversal is enabled.
D) The filter should be modified to also capture packets for TCP port 443 or UDP port 4500.

5. Which three factors about service-level agreement (SLA) targets and SD-WAN rules should you consider when configuring SD-WAN rules? (Choose three.)

A) When configuring an SD-WAN rule, you can select only one SLA target from a performance SLA.
B) When configuring an SD-WAN rule, you can select multiple SLA targets from the same performance SLA.
C) Member metrics are measured when an SLA target references them.
D) Best performance SD-WAN rules cannot use SLA targets.
E) SLA targets are used only by SD-WAN rules that are configured with a lowest cost (SLA) strategy.

Solutions: